Enabling remote control port

Andrew Schiestl (Intel)
Total Points:
3,473
Status Points:
2,973
Brown Belt
June 16, 2009 11:10 AM PDT
Rate
 
#1
Quoting - sorkargg
Hi,
while using manageability commander tool, I managed to connect to the vpro computer. Using the web interface I was able to reset the computer. But when I try to display the terminal it says :"Intel AMT remote control port is disabled. Please enable before entering terminal."
Funny thing is that I didn't have this message yesterday for the same action.

Where can I enable the remote control port?

So, you can get to the web interface and reset the computer through the web interface.  When you say you're trying to display the terminal, do you mean you're trying to use the Take Control button to establish a SOL session?  Mainly I want to make sure I know what you're trying to do through the Commander.

If that is what you're trying to do, you can check the setting through the Managability Commander  by going to the Remote Control tab after you connect to that system through the Commander.  You might need to go in to the MEBx to set the command

Also, what is your systems AMT version?

Intel Software Network Forums Statistics

8491 users have contributed to 31629 threads and 100770 posts to date.
In the past 24 hours, we have 28 new thread(s) 120 new posts(s), and 168 new user(s).

In the past 3 days, the most popular thread for everyone has been Implicite multithreading ??? The most posts were made to Crash when loading skeleton The post with the most views is Dear Steve, excuse me for a d

Please welcome our newest member shadowwolf99