Annotation Wizard - Page 3
helps you add annotations into your code. After you are done adding annotations, rebuild your program.
Use page 3 of the wizard to check the annotation line(s) that you defined using the wizard and verify that the line(s) and insertion location(s) are correct:
If you are satisfied with the annotation line(s), click
to add the line(s) to your code.
To revise the annotation, click
and revise the annotation type, or the parameters defining the annotation.
To change the location of the added lines, click
, select a different range of code lines and right-click and choose
> Annotation Wizard
to add annotation lines around the new selection.