User Guide

  • 2020
  • 06/18/2020
  • Public Content
Contents

Annotation Wizard - Page 3

The
Annotation Wizard
helps you add annotations into your code. After you are done adding annotations, rebuild your program.
Use page 3 of the wizard to check the annotation line(s) that you defined using the wizard and verify that the line(s) and insertion location(s) are correct:
  • If you are satisfied with the annotation line(s), click
    Finish
    to add the line(s) to your code.
  • To revise the annotation, click
    Back
    and revise the annotation type, or the parameters defining the annotation.
  • To change the location of the added lines, click
    Cancel
    , select a different range of code lines and right-click and choose
    Intel Advisor [version]
    > Annotation Wizard
    to add annotation lines around the new selection.

Product and Performance Information

1

Intel's compilers may or may not optimize to the same degree for non-Intel microprocessors for optimizations that are not unique to Intel microprocessors. These optimizations include SSE2, SSE3, and SSSE3 instruction sets and other optimizations. Intel does not guarantee the availability, functionality, or effectiveness of any optimization on microprocessors not manufactured by Intel. Microprocessor-dependent optimizations in this product are intended for use with Intel microprocessors. Certain optimizations not specific to Intel microarchitecture are reserved for Intel microprocessors. Please refer to the applicable product User and Reference Guides for more information regarding the specific instruction sets covered by this notice.

Notice revision #20110804