Configuring Metrics to Be Collected and Displayed in HUD
Intel® GPA supports a wide variety of metrics. The metrics available for display might differ depending on your specific graphics device.
NOTE
The HUD is not available in the stream mode.
To configure the metrics that are collected, do the following:
- Start the Graphics Monitor.
- On theGraphics Monitor Launcherscreen, click the
button.
- Go to theMetricstab and configure the available metrics options:
- Select theGPU Sampling Interval
- Enable/disable GPU metrics collection by the target application
- CustomizeSystem Analyzer HUD positionthe
- Configure the HUD metrics:
- Drag and drop a desired metric to add it to the list of metrics to be displayed in the System Analyzer HUD from the list of available metrics to the Active HUD Metrics list. You can select up to four metrics that are overlaid on your running application.
- To change the metrics that are displayed, you can remove a metric from the Active HUD Metrics list by dragging and dropping this metric back to the list of available HUD metrics; or reorder the Active HUD Metrics list by dragging and dropping a desired metric over another active metric; or hover over the metric to be removed, and then click theXbutton.
- Select the active metric set by using theActive Metric Setdrop-down menu in theGPUsection of the metric tree
Selecting the GPU Sampling Interval
In
Frame
mode, metrics are sampled every frame and are only collected from the target application. When you select any other value, System-Wide Time-Based metric collection is enabled. In this mode, Graphics Monitor collects metrics from the entire system with the selected frequency. This may interfere with profiling if other GPU-intensive applications are running. It is recommended to close other GPU-intensive applications when using any sampling interval other than Frame
.See Also