Screen: Options
To access the
button on the
Options
screen, click the

Graphics Monitor Launcher Screen
.The
Options
screen comprises the following tabs:NOTE
Settings in the
Metrics
tab and the Trigger
tab are not applicable to applications running in the Steam* mode.Metrics

Use the
Metrics
tab to do the following:- Enable/disable GPU metrics collection by the target application
- CustomizeSystem Analyzer HUD positionthe
- Configure the HUD metrics
- Select the active metric set from a list for each Intel Graphics processor
Metrics
tab comprises two lists:- List of all available HUD metrics.
- List of active HUD metrics.
To configure the HUD metrics to be shown in the target application, drag and drop a metric from the list of available metrics to the list of active metrics. The maximum number of active HUD metrics is four. To restore the default list of active HUD metrics, click the
button. To change the metrics that are displayed, you can remove a metric from the Active HUD Metrics list by dragging and dropping this metric back to the list of available HUD metrics, or reorder the Active HUD Metrics list by dragging and dropping a desired metric over another active metric.

Use the search bar at the top of the tab to find relevant metrics.
To select the active metric set, use the
Active Metric Set
drop-down menu in the GPU
section of the metric tree.
Shortcuts

To change a shortcut, click the shortcut value, and then click the buttons combination that you want to use as a new shortcut: start with a combination of modifier keys (ALT, CTRL, SHIFT, etc.) and end with an alpha-numeric character key.
To restore default shortcut values, click the
button.

Use the search field at the top of the tab to find relevant shortcuts.

The
Trigger
tab enables you to set a custom condition for system trace capturing. For instructions on setting up a trigger, see Setting up a Trigger.Trace
In the
Trace
tab you can modify tracing options:- Enable capturing a trace upon an application startup.
- Change the duration of the application run to be captured in a single trace file. By default, the trace duration is five seconds.
To restore the default tracing parameters, click the
button.

Use the search field at the top of the tab to find relevant domains.
Stream

Use the
Stream
tab to set configure the following stream capture settings:- Create a keyframe at a specified time interval.
- Create a keyframe upon pressing a key.
- Create screenshots in a specified sequence of frames.
- Create screenshots in a specified time interval.
- Enable/disable a HUD layer in the running application window.
- Enable/disable a Metrics layer in the running application window.
Frame

Use the
Frame
tab to set frame delimiters for OpenGL applications. Frame delimiter is an API call acting as a frame border. Set frame delimiters to enable Intel® GPA analysis for applications that do not use default frame delimiters.OpenGL Frame Delimiters:
- SwapBuffers
- SetCurrentContext
- glBlitFramebuffer
- glClear
- glFinish
- glFlush