User Guide

  • 2020
  • 10/21/2020
  • Public Content

Comparing Results

The information in an
Intel Inspector
results comparison is most useful when you compare two results of the same analysis type from the same project, such as two
Detect Leaks
) results.
To compare two results:
  1. Choose
    Results Comparison...
  2. In the
    Compare Results
    choose two
  3. On the
    toolbar, click the
Outcome: The
Intel Inspector
displays a result that looks similar to a standard analysis result with the following exceptions:
  • Result tab name - The
    Intel® Inspector
    shows the names of the results selected for comparison in the following manner:
    Results Comparison: "<Result 1 name>" - "<Result 2 name>"
  • State
    information - The
    Intel Inspector
    • Result 1
      Result 2
      if the issue was detected in only one of the results
    • Both
      if the issue was detected in both results
Intel Inspector
does not save result comparisons. The information disappears if you close the result tab, open another project,
or close the
Intel Inspector

Product and Performance Information


Intel's compilers may or may not optimize to the same degree for non-Intel microprocessors for optimizations that are not unique to Intel microprocessors. These optimizations include SSE2, SSE3, and SSSE3 instruction sets and other optimizations. Intel does not guarantee the availability, functionality, or effectiveness of any optimization on microprocessors not manufactured by Intel. Microprocessor-dependent optimizations in this product are intended for use with Intel microprocessors. Certain optimizations not specific to Intel microarchitecture are reserverd for Intel microprocessors. Please refer to the applicable product User and Reference Guides for more information regarding the specific instruction sets covered by this notice.

Notice revision #20110804