• 07/14/2017
  • Public Content
Contents

USB Type-C with OTG (J7)

The USB Type-C port provides the following functionality:
  • USB 3.0 and USB 2.0 interfaces
  • Supports inverted connector insertion by auto multiplexing of USB 3.0 lanes
  • Input for power source for expansion board; see USB Type-C Power Input (J7)
  • Power output of up to 900 mA for OTG device
  • Powered Configuration Channel (CC) lines (+5VDC levels up to 300 mA, each)
The USB Type-C connector VBUS pin can either act as a power input to the expansion board or power output from the expansion board. The default mode is using the USB Type-C connector as a power input. However, when software executing on the module detects that the port must switch to OTG mode, a load switch is enabled, which supplies power from the +5 volt boost regulator to the VBUS pin of the USB Type-C connector, through the +VBUS rail of the expansion board.
USB loads that exceed 900 mA limit can have unpredictable behavior. Device load on the Type-C connector is to be considered in total platform power needs when selecting power supply solutions.
USB Type-C Inverted Cable Mux (EU4)
The expansion board provides a USB multiplexer device to that is configured to detect and correct inverted cable configurations. Actual determination of cable inversion is performed by the module, activating USBC_SEC to control the mux as needed.

Product and Performance Information

1

Intel's compilers may or may not optimize to the same degree for non-Intel microprocessors for optimizations that are not unique to Intel microprocessors. These optimizations include SSE2, SSE3, and SSSE3 instruction sets and other optimizations. Intel does not guarantee the availability, functionality, or effectiveness of any optimization on microprocessors not manufactured by Intel. Microprocessor-dependent optimizations in this product are intended for use with Intel microprocessors. Certain optimizations not specific to Intel microarchitecture are reserved for Intel microprocessors. Please refer to the applicable product User and Reference Guides for more information regarding the specific instruction sets covered by this notice.

Notice revision #20110804