Intel® System Debugger - System Debug User and Reference Guide

User and Reference Guide

  • 2020
  • 07/29/2020
  • Public Content
Contents

Disconnecting from the Debugger

To terminate the debugging session and disconnect the target, follow the steps below:
  1. Stop the debugger by clicking the
    disconnect target
    Disconnect button in the middle of the toolbar.
    disconnect debugger toolbar
    Important
    The debug session is terminated now but your JTAG or Intel® DCI connection is still alive. To disconnect the target, do the next step.
  2. Ensure that the debugger is terminated and then disconnect the target by clicking the
    disconnect target
    Disconnect '<target name>'
     button next to the Connection field in the Eclipse* toolbar.
    disconnect target toolbar public
    The Target Connection Assistant terminates the connection.

Product and Performance Information

1

Intel's compilers may or may not optimize to the same degree for non-Intel microprocessors for optimizations that are not unique to Intel microprocessors. These optimizations include SSE2, SSE3, and SSSE3 instruction sets and other optimizations. Intel does not guarantee the availability, functionality, or effectiveness of any optimization on microprocessors not manufactured by Intel. Microprocessor-dependent optimizations in this product are intended for use with Intel microprocessors. Certain optimizations not specific to Intel microarchitecture are reserved for Intel microprocessors. Please refer to the applicable product User and Reference Guides for more information regarding the specific instruction sets covered by this notice.

Notice revision #20110804