User and Reference Guide

  • 2020
  • 07/29/2020
  • Public Content
Contents

Intel® In-Target Probe - Extended Debug Port (Intel® ITP-XDP)

  1. Plug in the probe power supply. The probe fan must start spinning. Failing to connect the power supply when the probe is in use will damage the probe.
  2. Plug the USB cable into the probe and into an USB2.0 (or greater) port of your host computer.
  3. Identify the XDP port on your target board, usually named "CPU XDP", and plug the small PCB with connector at the end of the ribbon cable to it.
  4. Power on the target board.

Product and Performance Information

1

Intel's compilers may or may not optimize to the same degree for non-Intel microprocessors for optimizations that are not unique to Intel microprocessors. These optimizations include SSE2, SSE3, and SSSE3 instruction sets and other optimizations. Intel does not guarantee the availability, functionality, or effectiveness of any optimization on microprocessors not manufactured by Intel. Microprocessor-dependent optimizations in this product are intended for use with Intel microprocessors. Certain optimizations not specific to Intel microarchitecture are reserved for Intel microprocessors. Please refer to the applicable product User and Reference Guides for more information regarding the specific instruction sets covered by this notice.

Notice revision #20110804