Intel® System Debugger - System Debug User and Reference Guide

User and Reference Guide

  • 2020
  • 07/29/2020
  • Public Content
Contents

Unable to Configure the IPC Provider

The debugger fails to connect to the target because it cannot configure the IPC provider. The following dialog box is displayed:
failed configure provider
Cause
You have an IPC provider already running on the system but the present connection is configured to change the provider.
Solutions
Try any of the following options:
  • Stop the IPC provider and try to connect to the target again.
  • Open the connection editor and uncheck the Update provider configuration for current connection box.

Product and Performance Information

1

Intel's compilers may or may not optimize to the same degree for non-Intel microprocessors for optimizations that are not unique to Intel microprocessors. These optimizations include SSE2, SSE3, and SSSE3 instruction sets and other optimizations. Intel does not guarantee the availability, functionality, or effectiveness of any optimization on microprocessors not manufactured by Intel. Microprocessor-dependent optimizations in this product are intended for use with Intel microprocessors. Certain optimizations not specific to Intel microarchitecture are reserved for Intel microprocessors. Please refer to the applicable product User and Reference Guides for more information regarding the specific instruction sets covered by this notice.

Notice revision #20110804