Video: How to Configure and Un-configure an Intel® vPro™ technology client (Intel® AMT) inside the MEBx Menus

If you have just purchased and Intel® AMT Client and are wondering how to get started managing your new system, you can watch this short ~10 minute video on how to quickly configure Intel AMT. This video also demonstrates how to unconfigure Intel AMT from inside the MEBx environment.

https://www.youtube.com/watch?v=hOZjBdsm_yY

Still have questions? Please go to our Developer's Forum and ask away!

For more complete information about compiler optimizations, see our Optimization Notice.

3 comments

Top
anonymous's picture

Hi,
Where is the video? No video or link showing up in IE9 or FF15.

--Mike

Gael H. (Intel)'s picture

Please post questions on our Developer's Forum: http://software.intel.com/en-us/forums/intel-vpro-software-development/

anonymous's picture

There is NO line for "unconfigure" and AMT is no longer detected on my Dell Optiplex 780.
It was previously version ME 5.1.0.0019, and it PREVIOUSLY WORKED! Just BIOS & chipset updates - nothing more.
It is a vPro system.
Prev was able to get to AMT functions and, at one time, long ago, I gave the AMT/vPro part a static ip.

But now, it always gives error during "Aquiring Intel AMT Configuration" - 2003-08 - ERROR FIRMWARE CONNECTION FAILURE.
AMT tab shows: MEI driver Enabled (5.2.0.1008) and LMS: Enabled (5.2.0.1034), Power Policy unknown.

I did have Dell send me a new power supply - and I replaced that, but that is all that has happened.

Prev BIOS was A09, still got same 'connection failure' on A09 (over the past 3+ months); so, recenty I updated to BIOS A12.
Still no go - same error. We tried resetting, but maybe we did not fully reset it???

Troubleshooting I have seen - mentions "Connection failure happens sometimes if the system has trouble getting to the IP of the ME/AMT portion."

Intel Management & Security Status app shows "AMT Reviewed, "Intel AMT disabled 03/29/2012" and "not detected," but shows ILS and the other thing
Only thing I did was add video card, which now I have removed, to make it back like it was.

Still no go.
I do not have a provisioning server - only using MEBx, but since there is NO 'unprovision' option, I am stuck! Need this to work.
HELP! Please.

Thanks!

Add a Comment

Have a technical question? Visit our forums. Have site or software product issues? Contact support.