Is it possible to set the learning rate to begin at a value less than 0.01? I would like to start at 0.001.
Have you tried to edit the "Base learning rate" field in the "Parameters" step in` the new image classification model wizard?
This should be the place to change the value...
Yes, I have tried to edit the base learning rate in the parameters section. But if you enter a value less that 0.01 it will not accept it. I have just noticed now that if you mouse over it a message is displayed "Value must be greater than of equal to 0.01".
So, as a feature request, it would be good if lower values could be set. When fine tuning off a pretrained model a lower base learning rate is preferred.
Thanks for your feedback - we will put it inside our backlog.