I am trying to set up an SCS test set up where all the necessary components like Database, CA. etc will be installed in one system. The main intention od setting up SCS is to automate Zero Touch Provisioning in enterprize mode. I have a few questions regarding this.
1. Would the Zero Touch Provisioning work if the systems are not in domain controller? SCS and AMT device however will be under same workgroup and could ping each other.
2. Is Active Diretctory manadatory in this case?
3. If I provision one AMT device with Manual process is it possible to unprovision the device and make it ready for Zero Touch Configuration again? I know that it could be unprovisioned but what I am wandering is if ZTC will work after that?
4. Is Activator tool mandatory in case of ZTC?
For your information I shall work with AMT version 3.X onwards.
I was following SCS installation and configuration guide to set up the environment. But had these confusion in rather basic stuffs. Thanks in advance.