Binary Configuration Tool

Binary Configuration Tool

I could not find a forum for the Binary Configuration Tool.  I am using the BCT to configure the FSP binary for a Baytrail Atom E3815 processor.  The BCT allows you to enable either or both of the HSUART ports.  If they are enabled, does the binary completely configure the registers?  If so, what is the base address for these devices?

BAR0 for Bus 0 Device 30 Function 3 and

BAR0 for Bus 0 Device 30 Function 4

 

4 posts / 0 new
Last post
For more complete information about compiler optimizations, see our Optimization Notice.

BCT isn't supported on this forum, or on IDZ in general. This is associated with Intel FSP, so please check this site for information: http://www.intel.com/content/www/us/en/intelligent-systems/intel-firmware-support-package/intel-fsp-overview.html

Going to that link and trying to get support brings me right back here!!!!!!!!!!!!!!!!!
 

You should be going to this community: http://embedded.communities.intel.com/community/en/software

Leave a Comment

Please sign in to add a comment. Not a member? Join today