No network support enabled/configured when you build from yocto meta-intel-iot-devkit

No network support enabled/configured when you build from yocto meta-intel-iot-devkit

When a user tries to build yocto image based on the following docs the Network support is not configured or plumbed to "eth0"

http://software.intel.com/sites/default/files/managed/f1/49/building_yocto_and__ipks.pdf

Built with "bitbake iot-devkit-prof-dev-image"

root@clanton:~# cat /proc/version

Linux version 3.8.7-yocto-standard (gmcollin@haro) (gcc version 4.8.1 (GCC) ) #1 Mon Apr 14 12:29:48 PDT 2014

root@clanton:~# ifconfig -a

lo        Link encap:Local Loopback  

          inet addr:127.0.0.1  Mask:255.0.0.0

          inet6 addr: ::1/128 Scope:Host

          UP LOOPBACK RUNNING  MTU:65536  Metric:1

          RX packets:12 errors:0 dropped:0 overruns:0 frame:0

          TX packets:12 errors:0 dropped:0 overruns:0 carrier:0

          collisions:0 txqueuelen:0 

          RX bytes:892 (892.0 B)  TX bytes:892 (892.0 B)

 

 

 

Zone: 

3 posts / 0 new
Last post
For more complete information about compiler optimizations, see our Optimization Notice.

What firmware do you have on your Galileo?
Also did you build from sstate download or from git sources. If git, which branch did you build from.
 

I updated it last week. Running Arduino 1.5.3. 

Built from git sources fails with networking.  The 4.5gb sstate version works fine.  

This is the steps I use to create a repo.

git clone git://git.yoctoproject.org/meta-intel-iot-devkit

 cd meta-intel-iot-devkit/

source iot-devkit-init-build-env

bitbake iot-devkit-prof-dev-image 

Leave a Comment

Please sign in to add a comment. Not a member? Join today