For standalone GUI:
Select and run the General Exploration analysis to discover what parts of the application code are being most used and see what hardware resources are being used there.
Create a Project (Standalone GUI only)
amplxe-varsscript, located in the product installation directory, to set up the environment.
From the Start menu select Intel Parallel Studio XE 2016 > Intel VTune Amplifier XE 2016 to launch the VTune Amplifier GUI client.
By default, the VTune Amplifier creates a project directory under the
%USERPROFILE%\My Documents\Amplifier\Projectsdirectory and opens the New Amplifier Result tab with the Analysis Target sub-tab active.
Specify Analysis Target
To specify your application as analysis target in the standalone VTune Amplifier GUI, configure the Analysis Target tab:
From the left pane, select the local type of the analysis system.
From the right pane, select the Launch Application type of the analysis target drop-down menu.
In the Application field, click the Browse button and navigate to the
Click the Choose Analysis button on the right to switch to the Analysis Type tab.
Configure and Run Analysis Type
General Exploration analysis collects event and IP information over a wide net of hardware issues that might affect application performance.
VTune Amplifier launches the
matrix application that calculates matrix transformations before exiting. When the application exits or after a predefined interval, depending on how the collection run was configured, collection is completed and the VTune Amplifier enters the finalization process, where data are coalesced, symbols are reconnected to their addresses, and certain data are cached to speed the display of results.
To make sure the performance of the application is repeatable, go through the entire tuning process on the same system with a minimal amount of other software executing.