I am trying to put into an AvGraph3D two plots: one is AV_HEIGHTPLOT and the other one is AV_XYZPLOT. I wonderif there isanything inherently illegal (i.e. not supported) about this arrangement?
I have modified the VB6 XYZPlot by adding two plots: anAV_XYZPLOT and anAV_HEIGHTPLOT(and hiding the two plots that were originally in the sample).The AV_XYZPLOT has "markers" (i.e symbols) at the Z-Source values of the line. Both plots do appear in the graph.However, it becomes apparent that, as the graph is "manually" rotated, the plots are not drawn correctly. Essentially, at certain orientations of the graph, some symbols (markers) of the AV_XYZPLOT plotappear to be abovethe surface of the AV_HEIGHTPLOT, while at other orientations they appear to be below. This is most noticeable when the AV_XYZPLOTplot has both line and symbols (markers) as it can be seen that the line of the AV_XYZPLOTdoes seem to cross the surface of the AV_HEIGHTPLOTatpretty much the same location, while the symbols do not (i.e. they do not always follow the line even though thesymbols and the lineuse the same source data values).