Start Serial Console on Galileo using Linux, w/ USB->UART FTDI cable

These instructions will allow you to start a serial console on your Intel Galileo board using Linux. The instructions assume an ubuntu/debian release and use apt-get for software installation, so if you're using another distribution, substitute apt-get with the relevant package management command for your system.

  1. Plug in the power and USB->UART FTDI cable
  2. Immediately after plugging in the cable, run dmesg:
    $ dmesg 
    ...
    [184943.625437] usb 3-2: FTDI USB Serial Device converter now attached to ttyUSB0
    
    The device listed at the end is the assigned serial device for your FTDI.
  3. Install cu:
    $ sudo apt-get install cu
    
  4. Set the user and group of the serial device to uucp:
    $ sudo chown uucp: /dev/ttyUSB0
    
  5. Connect:
    $ sudo cu -l /dev/ttyUSB0 -s 115200
    Connected.
    
    Poky 9.0 (Yocto Project 1.4 Reference Distro) 1.4.1 clanton /dev/ttyS1
    
    clanton login: 
    
  6. Login as user root, with no password:
    clanton login: root
    root@clanton:~# 
    

Happy Hacking!

Per informazioni più dettagliate sulle ottimizzazioni basate su compilatore, vedere il nostro Avviso sull'ottimizzazione.