In addition to this document and to Microsoft documents, Intel has made other documents available to help with gateways. These documents can be found on the Intel Developer Zone for IoT Gateways section by searching for "solution brief" or "recipe" for Windows operating system. A selection of documents includes (but is not limited to):
These steps make sure your Gateway has the latest evaluation operating system installed.
Obtain Evaluation OS
The evaluation OS is a general-purpose runtime image that you will use for Gateway development tasks.
Setup the Gateway to boot from USB using UEFI mode. Example instructions are below, but your specific instructions may vary by Gateway manufacturer. See the manufacturer's guide for your Gateway.
Build the Gateway OS
- In the $HOME/Projects directory on your Development Computer, build your Gateway OS image:
Try these ideas to enhance your development:
This guide assumes the reader has experience with the following:
Similar to module installation, we assume that a development computer is used to remotely control the gateway. To use the module, complete the following steps.
On the gateway, follow the same procedures as used in Module Installation to enable the remote PowerShell if it is not done yet.
On the development computer, do the following steps:
Your Gateway supports wired Ethernet and wireless connections. Setup a wired Ethernet connection first. This is needed in later steps. Then, if you need it, verify your wireless connection.