I need to measure the amount of AVX instructions my application executes. I modified the lightweight hotspots profile and added the necessary counters in it. However I experience several problems:1. When I try to launch the profiling process from vtune gui I get the error "error collection failed the data cannot be displayed". Other types of analysis work from gui. If I attempt to launch the process again I get the message that "Sampling session is already in progress" which I can solve only by reloading the kernel modules.I'm able to complete the lighweight hotspots analysis successfully if I launch the process from the cli with the command that I copy from gui. And what's more interesting after that successful attempt from cli the gui starts to work properly, so I can perform other sessions from it.These problems are inconvenient but more or less solvable.2. Another problem is that I am able get the data form a launch with small configuration which takes about 10 minutes to finish. But when I change the application's parameters to perform a 50 minutes run then at the end I get "error collection failed the data cannot be displayed" both from gui and cli.My configuration:CentOS 6.2 kernel 2.6.32-220.4.1vTune amplifier XE 2013(build 230230)2 e5-2690 processors + 128 GB RAM.I'll try to provide any additional information which may be needed.